Precautions before using the emergency power supply:
1. The product has just been received. Please turn on the flashlight to discharge it first, then charge the product for more than 4 hours before starting the car, because the product contains virtual electricity. This operation can extend the service life of the product!
2. It is recommended to start the car with the power supply at three levels or above 60%
3. Check whether the battery clipe head is clean
4. Start the car with ordinary clip: Check whether the blue port of the clip is inserted all the way, whether the clip contacts the positive and negative terminals of the battery with the largest area, and whether the clamp is stable and does not shake. First, clamp the positive and negative terminals of the clip to the positive and negative terminals of the battery respectively. and wait 2 to 3 minutes before starting the car. This can reduce the load on the power supply.
Emergency Light The LED lights of the jump starter include three modes (Normal, Strobe, SOS), which can be used in different emergencies.
Tips before use:
【1】The car cannot be continuously ignited to start the car / or the key is not released, and the next start will be carried out after 30 seconds between each start
【2】The positive and negative poles cannot be reversed. Two clips cannot be connected short-circuited.
【3】Remove the clip within 30 seconds after successfully starting the car.
Violation of the above 3 points may cause the [fuse box] of the clip to burn out, please pay attention to the operation method.
The Peak current 2000A is suitable for petrol vehicles up to 6.0L and diesel vehicles up to 4.0L
